For safety reasons, the Deutsche Verein des Gas- und Wasserfaches e. V. (DVGW, German Technical and Scientific Association for Gas and Water) normally requires an inspection of odorizing systems at least every four weeks. Lewa GmbH has now developed a new control system that continuously compares the set and actual values of the gas volume or odorant, so that these inspections can be eliminated or at least carried out at longer intervals. The odorant concentration can be configured in digital increments, eliminating the need for time-consuming control of the concentration by adjusting the stroke. Complete safety is retained, and remains equally high. The new OCU control (Odor Control Unit) will be presented at GAT together with Lewa odorizing systems for natural, bio, and liquid gas, and will be available starting in October.
The control system consists of one or two SPU power supplies or power packs, an OCU control unit used to control one or two solenoid-driven or motorized pumps and – depending on requirements – additional expansion assemblies. The CPU is built on a modular basis using 19" expansion cards and can be provided according to local conditions either in a 19" rack with a built-in motherboard or in a CC 7000 plastic wall housing with protection class IP66 – also with a built-in motherboard. The expansion cards for any additional inputs and outputs or special functions required, for example pertaining to filling logic, are interfaced using a plug-and-play system via the digital outputs of the SPU or via a bus.
All settings are configured in a dialog system using nine buttons, and different languages can be selected. Precision adjustment in digital steps of 0.1 µl//Nm³ or mg/Nm³ and automatic monitoring and readjustment allows odorant to be utilized optimally. The fill level is no longer measured using a probe with evaluation electronic as previously, but rather calculated based on parameterization during filling of the tank. In case of any deviations, there is a fully automatic correction in a closed control loop. The tolerance limit is ± 1 percent. Values above or below that range are reported as a fault using a red LED and in plain text on the backlit display. 200 error messages can also be stored with date and time. In case of a defective gas meter or for service purposes, the unit can be switched to "internal" mode, simulating any desired gas volume. Important operational data are not only available for registration, but can also be transmitted to the operator's control center, for example via the Lewa Netportal. The simple operation and elimination of time-consuming manual adjustment of the concentration by adjustment of the stroke reduces time requirements and ongoing costs for the operator.
In addition to the control system itself, there is another novel development that Lewa will be presenting at GAT: The pump housing and flow meter of the odorizing system on which the control system will be installed for the trade show are made of Plexiglas so that the internal moving parts of the system can be better seen. Normally, all parts in contact with fluid are fabricated of corrosion-resistant stainless steel. The layout of the system is based on applicable national and international regulations. Lewa relies very specifically on mature standard components that can be combined and extended in accordance with customer requirements. Odorizing systems can be used for many gases and gas mixtures, from natural gas to liquid gas, biogas and technical gases, and even oxygen or nitrogen. Depending on the application, magnetically, pneumatically, or electrically driven pumpes are used, with a maximum flow rate of 40 l/h and discharge pressures of up to 300 bar. In addition to their hermetic seal and precision metering, the modular design of these systems also ensures simple, safe, cost-effective operation and maintenance.
At GAT, Product Manager Walter Richter will be available for initial discussions and specific questions at Booth C 7.3 in the dm-arena.